Adjusting The Shoulder Strap; Inverting The Lever Position - Jacto HD-400 Operator's Manual

10- ADJUSTING THE SHOULDER STRAP

The tank is contoured for the operator comfort.
The shoulder straps can be quickly adjusted to properly
position the sprayer on the operator's back.
See below.
TIGHTENING
- Hold the strap buckle firmly with one hand,
and pull the handle downward with the other
hand.
Handle
Buckle
11- ATTENTION
After assembling the sprayer, fill the tank with clean water and pressure-check the
tank lid, diaphragm, tank bottom, lance and trigger valve for leakage. Most leaks can
be stopped by retightening the appropriate connections and fittings. Any leakage must
be repaired before returning to service.

12- INVERTING THE LEVER POSITION

This sprayer is assembled to mount the lever for left hand operation. In case you wish
to change its position, proceed as follows.
- Remove the locked ring (1) and washers (A) and the rod (2) of the chamber top.
- Turn the chamber top 180°.
- Reinstall the rod (2) on the chamber top, fit the washers (A) and secure the rod with
the locked ring (1) again.
- Then, remove the locked ring (4 and 5) and the washers (B).
- Remove the lever (6) and the shaft (7).
- Unfasten the strap assembly (8) and mount it on the other side of the sprayer as shown
in the detail below.
04
LOOSENING
- Hold the buckle firmly with one hand, and
pull the strap upward with the other hand.
Buckle
- Take the container cap off and carefully pour the rinse water into
the spray tank.
- Continue holding the container over the spray tank opening
for approximately 30 seconds to the last drop.
- REPEAT this operation twice more. This way, you complete the
TRIPLE WASH.
- The useless containers can be placed temporarily in an appropriate place, until final destina-
tion.
- In the case of mid and large size container (13.2, 26.4 and 52.8 gallons), after washing with the
appropriate volume (1/4 of the total) and fitting the cap, roll it on the ground for approximately 30
seconds.
- In the upright position complete the agitation by moving back and forth for approximately 30
seconds.
- Empty the container by pouring the rinse water into the spray tank.
- REPEAT this operation twice more. Finally, totally empty the container by pouring rinse water
in the spray tank.
- The least amount of rinse water that remains in the container, from one wash to the next, the
better the decontamination will be.
- For the performance of the TRIPLE WASH, do not use a water volume either much lower or
much higher than 1/4 of the container capacity.
-The TRIPLE WASH must be done IMMEDIATELY AFTER emptying the container, during the
preparation of the solution
- Next, make the plastic and metallic containers use-
less by piercing with a pointed instrument the contai-
ners bottom. This way, their labels are not damaged
for identification purposes.
SOURCE - ANDEF (NATIONAL ASSOCIATION OF VEGETAL DEFENSE)
13