Parts List - Jacto HD-400 Operator's Manual

PARTS LIST

14
6- INSTALLING THE LEVER ON THE SHAFT AND THE ROD ON THE CHAMBER TOP
- Lightly grease the orifice on the chamber
top.
- Fit a flat washer on the shaft and rod.
- For easy assembly, install the lever on
the shaft and the rod on the chamber
top at the same time.
- Install the other flat washers on the
shaft and rod and lock with the
locked ring.
Locked ring
7- ATTACHING THE LANCE TO THE TRIGGER VALVE
- Push the lance into the trigger valve and secure it with the screw cap.
Screw cap
Elbow
Lance
Do not overtighten the screw cap.
8- ATTACHING THE HOSE TO THE TRIGGER VALVE
- Unscrew the trigger valve handle.
- Remove the lock.
- Pass the hose through the randle and attach it
to the trigger valve as shown.
- Screw the handle on the trigger
valve.
9- TIGHTENING THE FASTENING NUT.
- Before using the equipment, tighten the fastening nut
(A).
Important: This operation must be carried out by hand.
Never use any type of tool.
Locked ring
Flat washers
Chamber
Rod
Lever
Flat washers
ATTENTION:
Trigger valve
Handle
Lock
Trigger
Hose
valve
ATTENTION: Do not overtighten the handle.
A
ilustrative
figure
Shaft
03