Installation - Honda 08E91-E22-101B Installation Instructions Manual

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1. Make sure you have the anti-theft code for the audio
unit and navigation system (if equipped), then write
down the radio station presets.
2. Disconnect the negative cable from the battery.
© 2008 American Honda Motor Co., Inc. – All Rights Reserved.
Setting the Control Unit
3. Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the locations
shown.
NOTE:
• The switches must be selected before the
control unit is plugged in.
• If the switch setting is not correct, the engine
starter will not operate properly.
• If you are setting the switches with the control
unit installed in the vehicle, touch a metal part of
the screwdriver to any metal part of the vehicle
to discharge any static electricity.
• If you change the switch settings with the unit
connected, you must disconnect the unit then
reconnect it for the settings to change.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREWDRIVER
SW:1 RR Junction unit ------------------- > OFF
SW:2 Trunk or Tailgate -------------------- > ON
SW:3 Smart Entry --------------------------- > OFF
SW:4 Horn or Buzzer Answerback ---- > OFF
SW:5 Trunk Main SW----------------------- > OFF
SW:6 Reserve--------------------------------- > OFF
AII 39870-40753 (0810)
Discharge any
static electricity.
SWITCHES
SWITCHES
SET
791717CH
3 of 20