Advertisement
Ground bolt
20 Wire ties
2
Long wire ties
8
Urethane tapes
A-Pillar clip
TOOLS AND SUPPLIES REQUIRED
Flat-tip screwdriver
Phillips screwdriver
Small flat-tip screwdriver
Ratchet
10 mm Socket
10 mm Combination wrench
Isopropyl alcohol
Shop towel
Tape measure
Clip remover
Scissors
Small rubber mallet
Honda Diagnostic System (HDS)
Masking tape
Needle nose pliers
2 of 23
Illustration of the Engine Starter Installed on the
Vehicle
ANTENNA
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1.
Make sure you have the anti-theft code for the radio,
then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
AII 38576-38846 (0802)
ENGINE STARTER
HARNESS
3 A FUSE
40 A FUSE
CASE
CASE
© 2008 American Honda Motor Co., Inc. – All Rights Reserved.
40 A FUSE
CASE
711102AY
Advertisement
