Tools And Supplies Required; Installation - Honda 08E91-E22-101A Installation Instructions Manual

TOOLS AND SUPPLIES REQUIRED

Phillips screwdriver
Flat-tip screwdriver
Diagonal cutters
Ratchet
8 mm, 10 mm, and 12 mm Sockets
10 mm Open end wrench
Trim Tool Set (SOJATP2014)
(Available through the Honda Tool and Equipment
program. On the iN, click on: Service/Service Bay/Tool
and Equipment Program, then enter the number under
"Search." Or call 888-424-6857.)
Isopropyl alcohol
Scissors
Small flat-tip screwdriver
Shop towel
Tape measure
HDS (Honda Diagnostic System)
Needle nose pliers
Torque wrench
Masking tape
Illustration of the Remote Control Engine Starter
Installed on the Vehicle
RELAY
3A FUSE
CONTROL
UNIT
40A FUSE
ENGINE STARTER
HARNESS
2 of 22
ANTENNA
021516AY
AII 43923 (1009)

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1. Make sure you have the anti-theft code for the audio
unit and navigation system (if equipped), then write
down the radio station presets.
2. Move the driver's seat all the way back.
3. Remove the air duct (two clips).
4. Disconnect the negative cable from the battery.
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
CLIP
AIR DUCT
012903AD