System Leds - NETGEAR FS700TS Hardware Installation Manual

Table 3-2. Port LEDs – PoE Devices (continued)
Port
24-10/100M Ports - One
LED/Port (PoE Mode)
4-Gigabits Copper Ports -
Two LED's/Port on Jack
2-SFP Ports - One LED/
Port

System LEDs

The following table describes the system LED designations.
Table 3-3. System LEDs
LED
Mode selecting LED (affects ports
1-24)
Stack ID LED - One Seven
segment LED Display
Stack Master LED
Physical Description
LED
POE Indicate LED/POE
fault
Left LED Link/ACT/SPD
LED:
SFP Link/ACT LED
Designation
• Solid Green - LED Mode in Ethernet LED Mode (default).
• Solid Yellow - LED Mode in PoE LED Mode.
• Off - the device is in standalone mode.
• Green - Displays Stack ID (1-6).
• Off - Switch acts as a slave member in a stack of switches.
• Solid Green - Switch acts as a master unit in a stack of switches. The
Stack Master LED is lit if there is an active stack link, and the unit is in
stack mode.
v1.0, September 2007
FS700TS Hardware Installation Guide
Designation
• Off - No PoE-powered device (PD) connected.
• Solid Green - The PoE powered device (PD) is
connected and the port is supplying power
successfully.
• Solid Yellow - Indicates one of the following
failures resulted in stopping power to that port:
•Short circuit on PoE power circuit.
•PoE power demand exceeds power available.
•PoE current exceeds PD's Classification.
•Out of proper voltage band (44-57 VDC).
• Off - No 10/100/1000Mbps link is established on
the port.
• Solid Green - A valid 1000Mbps link is established
on the port.
• Solid Yellow - A valid 10/100Mbps link is
established on the port.
• Flashing Green - Packet transmission or reception
is occurring on the port at 1000Mbps.
• Flashing Yellow - Packet transmission or
reception is occurring on the port at 10/100Mbps.
• Off - No link is established on the port.
• Solid Green - A valid link is established on the
port.
• Flashing Green - Packet transmission or reception
is occurring on the port.
3-24