Led Designations; Port Leds; System Leds; Device Hardware Interfaces - NETGEAR XS728T Hardware Installation Manual

LED Designations

The following sections describe the LED designations.

Port LEDs

The following table describes the RJ-45 and SFP+ port LED designations. A separate
indicator LED is associated with each port.
Table 1. Port LEDs
LED
Link/Speed/ACT LED mode for
copper ports 1 to 24
Link/ACT LED for SFP+ ports
25 to 28

System LEDs

The following table describes the system LED designations.
Table 2. System LEDs
LED
Power
Fan

Device Hardware Interfaces

The following sections describe the hardware interfaces on the device.
XS728T Smart Switch
Designation
• Off. No link established.
• Solid green. A valid 10G link is established.
• Blinking green. The port is transmitting or receiving packets at
10 Gbps.
• Solid yellow . A valid 1000M link is established.
• Blinking yellow. The port is transmitting or receiving packets
at 1000 Mbps.
• Off . No SFP+ module link is established.
• Solid green . A valid 10G link is established.
• Blinking green. The port is transmitting or receiving packets
at 10 Gbps.
• Solid yellow . A valid 1000M link is established.
• Blinking yellow . The port is transmitting or receiving packets at
1000 Mbps.
Designation
• Solid green . The device is powered on. Runtime code is operating.
• Solid yellow . The device is booting.
• Off . Power is not supplied to the device.
• Solid yellow . The fan experienced a failure.
• Off . The fan is operating normally.
Physical Description
11