Sfp Gbic Module; Factory Defaults Button - NETGEAR FS700TS Hardware Installation Manual

FS700TS Hardware Installation Guide

SFP GBIC Module

The GBIC module bays accommodate standard SFP GBIC modules, such as the AGM731F,
AGM732F, or AGM733 from NETGEAR, allowing fiber connections on the network. The module
bay is a combo port, sharing a connection with an RJ-45 port. Being a combo port, only one type
of connection can be active at any given time. For example, both copper and fiber port cannot be
used at the same time. If both connectors are plugged in at the same time, the fiber port becomes
active.
The SFP GBIC bay accommodates a standard SFP GBIC module.

Factory Defaults Button

The Smart Switch has a Factory default button to enable clearing the current configuration and
returning the device back to the factory settings. This removes all settings, including the password,
VLAN settings and port configurations.
Physical Description 3-26
v1.0, September 2007