Sfp Port Leds; System Leds - NETGEAR GS728TS Hardware Installation Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide

SFP Port LEDs

The following table describes the dedicated SFP port LED designations. Each SFP port has
its own indication LED.
LED
SFP Mode for 2 Combo Ports:
SPD/Link/ACT LED
SFP Mode for last 4 SFP Ports:
SPD/Link/ACT LED
Note: If the port media change to copper, the SFP port LED will change to
the OFF status.

System LEDs

The following table describes the system LED designations.
LED
Power
Fan
Stack Master LED
Stack ID
18 | Chapter 2. Physical Description
Designation
• Off— No SFP module link is established.
• Solid Green — A valid 1000Mbps SFP module link is established.
• Blinking Green — The port is transmitting or receiving packets at
1000Mbps.
• Solid Yellow — A valid 100Mbps SFP module link is established.
• Blinking Yellow — The port is transmitting or receiving packets
at 100Mbps.
• Off—No SFP module link is established on the port.
• Solid Green—A valid 1000/2500Mbps SFP module link is established
on the port.
• Blinking Green—Packets transmission or reception is occurring on the
port at 1000/2500Mbps.
Designation
• Solid Green — Device is powered on, run-time code is up and running.
• Solid Yellow — Device is booting up.
• Off — Power is not supplied to the device
• Solid Yellow — Fan has experienced a fail.
• Off — Fan is operating normally.
• Solid Green — The switch acts as a master unit in a stack of GS700TS series
switches.
• Off — The switch acts as a slave in a stack of GS700TS series switches, or the
stack is operating in standalone mode.
Displays the stack ID, from 1 to 6.