Led Designations; Port Leds - NETGEAR FS700TS Hardware Installation Manual

Figure 3-6 illustrates the NETGEAR FS752TPS Smart Switch back panel:
Figure 3-6
The back panel contains the following:
• A 100-240VAC/50-60 Hz universal input, which is a standard AC power receptacle for
accommodating the supplied power cord.

LED Designations

This section provides an explanation for the following LED types:
•

"Port LEDs"

• "System LEDs"
Port LEDs
The following table describes the port LED designations.
Table 3-1. Port LEDS – Non-LED Devices
Port
24/48-10/100M Ports -
One LED/Port
Physical Description
LED
Link/ACT/SPD LED
v1.0, September 2007
FS700TS Hardware Installation Guide
Designation
• Off - No 10/100Mbps link is established on the port.
• Solid Green - A valid 100Mbps link is established
on the port.
• Flashing Green - Packet transmission or reception
is occurring on the port at 100Mbps.
• Solid Yellow - A valid 10Mbps link is established
on the port.
• Flashing Yellow - Packet transmission or
reception is occurring on the port at 10Mbps.
3-22