Operation - Makita HM0860C Instruction Manual

1
1. Bit
2. Chuck cover

OPERATION

Insert the bit into the tool. Turn the bit and push it in until it engages.
004484
If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a cou-
ple of times. Then insert the bit again. Turn the bit and push it in until it
engages.
After installing, always make sure that the bit is securely held in place by trying
to pull it out.
2
To remove the bit, pull the chuck cover down all the way and pull the bit out.
004485
Bit angle
004486
The bit can be secured at 12 different angles. To change the bit angle, slide
the change ring forward, then turn the change ring to change the bit angle. At
the desired angle, slide the change ring back to the original position. The bit
will be secured in place.
004487
CAUTION:
• Always use the side grip (auxiliary handle) and firmly hold the tool by
both side grip and switch handle during operations.
Chipping/Scaling/Demolition
Hold the tool firmly with both hands. Turn the tool on and apply slight pressure
on the tool so that the tool will not bounce around, uncontrolled. Pressing very
hard on the tool will not increase the efficiency.
7