Makita HM0860C Instruction Manual page 9

1
1. Terminal
1. Screw
2. Crank cap
1
1. Hammer grease
1
1. Terminal
Disconnect the terminal by pulling it.
004491
Remove the crank cap by loosening the screws with a screwdriver. Rest the
004492
tool on the table with the bit end pointing upwards. This will allow the old
1
grease to collect inside the crank housing.
2
Wipe out the old grease inside and replace with a fresh grease (30 g). Use
004493
only Makita genuine hammer grease (optional accessory). Filling with more
than the specified amount of grease (approx. 30 g) can cause faulty hammer-
ing action or tool failure. Fill only with the specified amount of grease.
Reinstall the crank cap and secure with the screws.
Connect the terminal and reinstall the handle.
004494
CAUTION:
• Be careful not to damage the terminal or lead wires especially when
wiping out the old grease or installing the handle.
• Whenever reinstalling the handle, use the two short screws for the upper
side and two long screws for the lower side.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
9