Table of Contents
Advertisement
PLEASE NOTE: The long length of blue tubing used to flush your prefilters is the tubing you will use to
hook up both the water storage tank as well as the dedicated Reverse Osmosis faucet that came with
your system.
You will need to cut this length of blue tubing in two pieces accordingly. The length of tubing used to
hook up your kitchen faucet (which will be attached to the left side of the Polishing Filter) will prob-
ably need to be longer than the length of blue tubing used to hook up your R.O Water Holding tank
(which will be attached to the right side of the Polishing Filter). Take a moment and judge how much
tubing you will need for each purpose based upon where the final placement of your system will be
located under your sink (or the like)
and then cut the blue tubing to
Figure 19
length with a sharp knife making sure
Attach the tank
your cut is straight (not at an angle).
top valve to the
Final Polishing
Now insert one end of the cut length
of blue tubing (for the tank) into the
Filter
male "T" adaptor found on the right
side of the Final Polishing Filter and
the other end into the tank top valve
connecting the holding tank to the
system (Fig. 19).
11.0 Clear the Decks.
If you have not already done so, the next step is to totally clean out under your sink. Get some rags to
wipe up any water drips that may be present from the installation process. Now, step back and look at
where you want the unit and the tank positioned. Please remember, you have to service the system so
consider accessibility.
TIP
Stand the unit inside a drip pan. Disposable aluminum baking sheets work fine. We suggest this
because you may have water drips while servicing the system or when you change out filters.
12.0 Preparing the Discharge Water Saddle Clamp.
Find a location on the drain pipe under
your sink where you wish to secure the
Figure 20
discharge water saddle clamp found
Where to install
in your Large Parts Bag (Fig 20). Make
the drain saddle
sure—MAKE REALLY SURE — that the
location you have chosen is above the
clamp
trap! (The trap is the "U" shaped part
of the drain pipe) You may secure the
saddle clamp on a horizontal pipe JUST
AS LONG AS YOU ARE ABOVE THE TRAP!!!
Also try to secure the saddle clamp
where it will not block anything, like
where you want to put your system or
the R.O. Water Holding Tank.
Final Polishing Filter
www.aquasafecanada.com
OK
NOT OK
www.aquasafecanada.com | Maximus II Installation Instructions 05/13 | page 11
Connect the Polishing Filter to the tank top valve
using a length of blue tubing cut to t your setup
sink
You can install the
saddle clamp on
horizontal
or vertical pipes
Do NOT install the drain saddle
clamp inside the dashed line area.
Trap
It MUST be installed above the trap
sink
OK
Advertisement
Table of Contents
