Setting The Handwheel Scale - DURKOPP ADLER H-Type 969 Service Instructions Manual

Setting the handwheel scale

5
Proper setting
Lock the machine in place at position 2 ( p. 19).
 The handwheel is at the 180° position.
Cover
• Remove handwheel and belt cover ( p. 13).
Fig. 15: Setting the handwheel scale
①
(1) - Screws
(2) - Handwheel
Setting steps
1. Remove the belt cover and handwheel ( p. 13), and take off the ridged
2. Loosen the screws (1).
3. Install the belt cover and handwheel.
4. Lock the machine in place at position 2 ( p. 19).
5. Set the handwheel (2) to 180° position ( p. 20).
6. Slide the hex key through the opening (3) and into the adjusting screw,
7. Remove the belt cover and handwheel ( p. 13).
8. Tighten the screws (1).
9. Install the ridged drive belt together with the belt cover and handwheel.
Service Instructions 969 - 01.0 - 12/2015
Setting the handwheel scale
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch the machine off before you check and set
the position of the handwheel on the arm shaft.
drive belt ( p. 25).
then tighten the screw.
(3) - Opening for the hex key
③
②
23