Table of Contents
Advertisement
2. Set the upper stitch length adjusting wheel to 0.
3. Loosen the setscrews (2).
4. Turn the stroke eccentric (1) so that the feeding foot touches down on
5. Tighten the setscrews (2).
6. Loosen the setscrew (4) far enough so that the plates (3) are in a line
64
the feed dog when the handwheel is in the 95° position, and the tip of
the needle is at the height of the upper edge of the feeding foot.
When doing so, do not move the stroke eccentric (1) laterally on the
axle.
again.
Adjusting the sewing foot feed
Service Instructions 969 - 01.0 - 12/2015
Advertisement
Table of Contents
