Table of Contents
Advertisement
Setting the feed dog
Fig. 28: Moving the feed dog carrier
③
④
⑤
Setting steps
1. Set the upper stitch length adjusting wheel to 0.
2. Loosen the clamp (3) and adjusting ring (1).
3. Loosen the clamp (5) and adjusting ring (6).
4. Move the feed dog carrier perpendicular to the sewing direction so that
5. Slide the adjusting ring (1) and pin (7) toward each other as far as they
6. Tighten the adjusting ring (1) and the clamp (3).
7. Slide the adjusting ring (6) and clamp (5) toward each other as far as
8. Tighten the adjusting ring (6) and the clamp (5).
Service Instructions 969 - 01.0 - 12/2015
②
(1) - Adjusting ring
(2) - Stroke shaft
(3) - Clamp
(4) - Sliding shaft
the feed dog is exactly in the center of the throat plate cut-out.
will go.
When doing this, make sure that the stroke shaft (2) is held firmly in
place by the pin (7) and the adjusting ring (1).
they will go. When doing this, make sure that the sliding shaft (4) is held
firmly in place by the clamp (5) and the adjusting ring (6).
①
⑦
⑥
(5) - Clamp
(6) - Adjusting ring
(7) - Bolt
41
Advertisement
Table of Contents
