Advertisement
I) °C/°F temperature unit setting
The default temperature reading is set to °C (degree Celsius). To select °F (degree Fahrenheit):
1. The "°C" will be fl ashing, use the "CH/ +" button (3) to toggle
between "°C" and "°F".
2. Once the desired temperature unit has been chosen, confi rm
with the "SET" button (1) and enter the "Weather Forecast Icon
Sensitivity setting" or exit the setting mode by pressing the
"SNOOZE/ SUN" button (5).
J) Weather forecast icon sensitivity setting
For locations with rapid changes of weather conditions, the threshold can be set to a different level for
faster display of changing weather conditions.
1. Press the "CH/ +" button (3) to set the weather sensitivity level.
There are 3 levels of setting: 1, 2 and 3; level 1 is the most sensitive
setting, level 3 is the least sensitive setting (default setting is "2").
2. Confi rm with the "SET" button (1) and exit the Manual settings.
K) Alarm setting
To set alarm:
1. Press and hold the "ALM" button (4) for about 3 seconds until the
alarm time display fl ashes.
2. The hour digit and the alarm icon will be fl ashing. Press the
"CH/ +" button (3) to adjust the hour.
3. Press the "ALM" button (4) once and the minute digit will start
fl ashing. Press then the "CH/ +" button (3) to set the minutes.
4. Press the "ALM" button (4) once to confi rm the setting.
5. To activate/ deactivate the alarm function, press the "ALM"
button (4) once. The display of the alarm icon represents that the
alarm is "ON".
46
B) Installation de l'émetteur de température externe
La potence peut être installée aux deux
extrémités de l'émetteur externe ; ainsi, il est
possible d'installer l'émetteur sur toute surface
plane.
La potence peut être fi xée au mur à l'aide des
deux vis fournies.
1. A cet effet, fi xer la potence à l'aide des vis
et des chevilles à l'endroit souhaité sur un
mur vertical.
2. Placer l'émetteur externe dans la potence.
67
Advertisement
Chapters
