General Safety Information; Duct Installation - Airrex HSC-18PLUS Operating Instructions And Parts Manual

Operating Instruction & Parts Manual Operating Instruction & Parts Manual

GENERAL SAFETY INFORMATION

* Ensure the safety of the location in which cooler is to be used.
* Ensure you allow at least 20inch air space all around the cooler.
* Never use the cooler at more than 2。 incline.
FOR MAXIMUM EFFICIENCY
*In airtight areas use vertical exhaust into ceiling.
* If possible locate exhaust outlet through a window
or door to outside.
* Ensure correct electricity supply.
The following instructions are for ensuring the user's safety and to prevent any physical injury or material
damage. Please read carefully and follow all instructions. There are two sections to these instructions:
WARNING and CAUTION.
* Use a 115V~ 60Hz (HSC-18PLUS), 220V~ 60Hz (HSC-24PLUS) 1 Phase power supply only.
(Wrong supply may cause a fire and / or shock hazard)
* Securely plug into a grounded outlet. (Unless earthed, may cause electric shock)
* Do not use a damaged power cable, plug or socket. (Short, fire or shock hazard)
* Do not remove plug by pulling cable or with wet hands. (Risk of fire and electric shock)
* Before cleaning, remove plug from socket. (Otherwise risk of electric shock)
* Do not place anything on top of the machine.
(This could cause electric shock, malfunction or injury)
* Do not use an extension cord. (Risk of fire and / or electric shock)
* Do not 'kink' or sharply bend the power cable nor put any weight on it.
(The insulation may be damaged causing fire and/ or electric shock)
* Do not turn off by removing power plug. Always turn off at control panel first.
(Risk of electric shock and / or malfunction)
* Do not use this cooler on unstable or inclined surfaces. Always use on solid
flat floor. (Risk of falling causing injury, fire or malfunction)
* A damaged power supply cable must be replaced with a new power supply
cord obtained from the product manufacturer and not repaired.
* Do not place cooler on uneven, unstable or inclined surface.
(This could cause malfunction)
* When storing the cooler, ensure that it is kept in a dry, cool place.
(To prevent corrosion and malfunction)
* If not being used for some time or if lightening is present, always unplug
from power. (To prevent risk of electric shock, short circuit or fire)
* Do not spray water on to the cooler nor use solvents such as benzene,
thinner or alcohol for cleaning. (There is a risk of electric shock and / or short circuit)
* Designed for indoor usage.
* Ensure the floor or ground is smooth and sound.
* When in position LOCK the casters to prevent rolling.

DUCT INSTALLATION

* The duct should be established before using.
(Standard Duct Size : 1ft, 5" dia.)
rev0