Operation; Control Panel - Airrex HSC-18PLUS Operating Instructions And Parts Manual

Operating Instruction & Parts Manual

OPERATION

CONTROL PANEL

① Power : Use to power On / Off.
: Raises or lowers setting temperature and/ or sleep (off) time.
②
③ Cool : Use to select cooling mode.
④ Fan Speed : Controls fan low / high speed.
⑤ Off Timer : To set the length of operating time, once turned on, that you wish the
cooler to run for. You can set 0~24 hours. Time intervals are
30mins. up to 10 hours and then 1 hour between 10 and 24 hours.
⑥ Remote : From the long distance (10~20m), you can control the machine by wired remote control.
⑦ Room : If the LED is On, the displayed temperature is for Room temp. If the LED is Off,
the displayed temperature is for spot temp.
⑧ Comp. : When the compressor is operating, the LED is On.
⑨ Error : Error signal ( E1 : High Pressure, E2 : Low Pressure, E3 : Sensor, AF: Eva Freezing)
⑩ Check : If Water full or Align Drain Tank is checking. The LED is On.
⑪ Display : Display Room/Spot temperature, the setting temp and off time in case of
setting them. When the user set the off timer, 'hr' will be turned on.
(Display of 'LO' : under the 32℉, Display of 'HI' : over the 99℉)
⑫ IR Remote Signal Receiver Window : Remote control signal is received by wireless remocon.
RUNNING & STOP
1. START BY PRESSING THE 'POWER' BUTTON.
·Cooler will start up automatically.
·To STOP the unit, press the 'POWER' button once again.
2.To change fan speed, press the 'FAN' button.
3.If you wish to operate on fan only, press the 'COOL' button. To resume cooling,
press the 'COOL' button again.
(Note : There is a 3 minute delay when switching functions to protect the compressor)
⑫
⑪
⑦ ⑥ ⑧ ⑨
⑤
② ③
④
⑩
①