Table of Contents
Advertisement
ERROR MESSAGES & COUNTERMEASURES
Symptom
When inputting monochrome image signal
(without burst signal), sync. becomes unstable.
The colour or picture quality is different between Is the image on the monitor screen adjusted?
the image on the monitor screen and the
printed image. (When the colour and picture
quality are same between the image stored in
the memory and the printed image.)
The set comments do not appear on the
print paper.
Wired remote control unit cannot be operated.
The printing unit cannot be opened.
"CHECK EXIT" message is displayed though
the printed paper is not left at the paper outlet.
46
Check and Remedy
Is INPUT in ANALOG COLOR ADJ set to "COLOR"?
→ Set INPUT to "B&W". Refer to page 40.
→ Adjust the image on the monitor screen with "MONI R-SUB" and "MONI B-
SUB" in the OUTPUT menu.
Refer to page 41.
Is the COMMENT set to "OFF"?
→ Set COMMENT to "ON". Refer to page 35.
Is the comment inputted?
→ Input the comment on the menu. Refer to pages 35-36.
Is the plug of the remote control unit disconnected from its terminal on the
unit?
→ Connect the plug of the remote control unit to the REMOTE terminal on
the unit.
The supplied remote control unit can not be used by connecting to the
external remote terminal on the rear panel of this unit.
Is the wired remote control unit for this unit (accessory) used?
→ Use the remote control unit for this unit.
Is PAPER HOLD set to "ON", and is printed paper kept at the print outlet?
→ Remove the printed paper from the print outlet.
Is the KEY LOCK set to ON?
→ Set the KEY LOCK to OFF.
Is the paper cut after prinitng with THERMAL : ON and AUTO CUT : OFF?
→ Press MEMORY button while pressing MONITOR button to cut the printed
paper.
The sensor for detecting remaining paper may fail to work properly due to
infrared light and so on.
→ Set CHECK EXIT of LAYOUT2&SYSTEM2 in SERVICE MENU to "OFF".
Advertisement
Table of Contents
