Table of Contents
Advertisement
Dust or other foreign matter adhering to the print paper or the sheet cartridge, or deformation resulting from exposure to
extremely low or high temperatures could cause loss of colour, uneven colour or lines, or wrinkles in the print images.
If there is noise or vibration in the VCR still-image or playback picture, the print image may be distorted or the upper part may be
crooked.
NOTE:
YOUR UNDERSTANDING IS REQUESTED FOR THE LOSS OF IMAGES IN MEMORY DUE TO THE SUDDEN
OCCURRENCE OF A MALFUNCTION.
•
When the remaining length of the paper is about 25cm (10"), a color belt appears at the paper end. Prepare for replacement
of the paper. If the remaining paper length is less than 25cm (10"), printing becomes uneven due to the uneven paper core
surface.
•
When the printed paper is touched by wet hand, the print may be discoloured.
•
When the paper runs out during printing, the printing operation stops and "CHANGE PAPER" is displayed on the monitor.
Install new paper at this time.
•
Store the printed paper in a place with low humidity free from a direct sunlight.
•
If the paper absorbs nonvolatile organic solvents (alcohol, ester, ketone, etc.) the print may be discoloured.
Particularly, if the paper comes in contact with soft vinyl chloride such as a transparent tape, it quickens discoloration.
•
Do not use paper other than the specified one.
•
Immediately after the paper is replaced, 2-3 images may be printed with a blank part due to hand's dust or oil.
•
Avoid a direct sunlight or a place near a heater, and store the paper in a place with 30°C (86°F) or lower temperature and
35-80% RH.
•
When the paper is rapidly transferred from a cool place to a hot place, a vapour or a dew is generated on the paper surface
causing paper jam or degraded printing quality.
•
A finger print or dust on the paper surface may degrade the printing quality.
Note:
Mitsubishi brand thermal paper is specially treated with an antistatic coating against thermal head damage caused by static-
electricity discharge.
The use of non-treated paper may cause premature head failure in your product.
OTHER CAUTIONS
THERMAL PAPER
5
Advertisement
Table of Contents
