Solving Software Problems - IBM Aptiva Reference Manual

Solving software problems

If the problem is...
Computer does not go on
Standby
48
Here's what to do...
The following steps can be tried on systems that exit
Standby when the system detects motion of the
keyboard, mouse or drives:
1 Make sure you don't touch the mouse or keyboard,
and don't start a program that involves using the
modem or drives. These activities reset the timer.
2 Make sure you leave the mouse on a surface that
does not vibrate. Leaving the mouse on top of your
computer or on top of another machine may reset the
timer before the set time has elapsed.
3 Allow a few minutes more than the specified time.
Windows periodically accesses the hard disk drive for
memory swapping and this activity resets the timer.
Windows might access the hard disk drive for a short
time after you last touched your computer.
4 Try disabling AutoPlay of the CD or DVD drives. When
AutoPlay is enabled, the Power Management
software may detect activity in the CD or DVD drive
and keep the computer from going on Standby. For
information about CD and DVD drive checking, see
the Configuration topic in the Aptiva online help.
Periodically use the IBM Update Connector to look for
available updates for the software that came from the factory
with your computer. For information about the IBM Update
Connector, see the Aptiva online help.
If any of these problems continue after taking the actions
listed, run the diagnostics programs that came with your
computer. If you need service, see "HelpWare support and
services" on page 79.
Solving software problems