Panasonic WJ-NV300K Installation Manual page 30

Connection for the auto time adjustment function
When a signal output from the other device is supplied to the time adjustment signal input (pin no. 20) and the time difference
between the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other
device.
When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour
(nn:00:00). ("nn" is the hour.)
Example:
• Signal is supplied at 2:50:00 pm
• Signal input supplied at 3:28:45 pm
• Signal is supplied at 3:29:30 pm
Important:
• The clock will not be adjusted during recording.
Note:
• When adjusting the time using the time adjustment signal input, select "On" for "Auto time adjustment". (
Instructions (PDF))
Connection of the control output
When an alarm device such as a buzzer or a lamp is connected, the signal output from pin no. 10 and pin nos. 15 - 19 can be
used to notify the status by sounding a buzzer or lighting a lamp.
The connection example of the HDD error output (pin no. 16) is as follows.
30
→ Set at 3:00:00 pm
→ Set at 3:00:00 pm
→ Time will not be adjusted.
(Signal ground)
(Time adjustment signal input)
13 20
ALARM/CONTROL
(Signal ground)
(HDD error output)
13 16
ALARM/CONTROL
Terminal of the other device
Alarming device
* Attached when necessary
Output for the
indicators on
the front panel
☞ Operating
Relays, etc.*