Operating Instructions; Charging Procedure - Motorola IMPRES User Manual

OPERATING INSTRUCTIONS

The IMPRES Adaptive Single-Unit Charger System is a fully
automated battery care system. All a user needs to do is follow
these simple steps:
1. Place the radio / IMPRES battery into the charger.
2. Remove the radio / IMPRES battery when it's fully charged
(LED turns steady GREEN).
The charger's pocket accommodates either a radio with an
IMPRES battery attached or an IMPRES battery alone. Prior to
charging a radio with an IMPRES battery, turn the radio off.
Batteries charge best at room temperature.

Charging Procedure

1. Plug the charger end of the power supply cord into the power
receptacle located at the back of the charger.
2. Plug the wall receptacle end of the power supply cord into the
appropriate AC outlet. A successful power-up sequence is
indicated by a SINGLE GREEN BLINK on the charger
indicator.
3. Insert an IMPRES battery, or a radio with an IMPRES battery
(with the radio turned off), into the charger's pocket by:
a. Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger
pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring
complete contact between the charger and battery
contacts.
5