Automatic Synchronization; Manual Synchronization - Clas Ohlson ws2370 User Manual

Synchronize outdoor temperature

Automatic Synchronization

1. Learn function executes automatically
and runs for approximately 3 minutes
when batteries are first installed in the
receiver.
. Within these 3 minutes, receiver will
beep and picks up the temperature sig-
nals from transmitter(s) and displays the
readings.
Note. If the signals are not received within this 3 minutes, the outside tem-
perature will show "– ––". During this time, bringing the unit close together or
try different location and restart the auto learning function by removing and
replacing the batteries for receiver.

Manual Synchronization

1. Press and hold CHANNEL for 3 seconds in clock display mode.
. Beep sound indicates
that the synchroniza-
tion has started.
3. Channel number will
flash and unit will
beep as each remote
sensor is detected
4. The temperature is
shown on the display.
Note. Synchonization executes automatically and runs for approximately
3 minutes. If that fail, make sure the transmission within range or try different
location.
6