Getting Started - Clas Ohlson ws2370 User Manual

Getting started

Read this before you begin
1. Insert batteries for the remote transmitter(s) first, and then the receiver.
. Place the receiver and the remote transmitter(s) close together. This will
ensure that the receiver can synchronize with the remote transmitter(s).
3. Place the remote transmitter(s) within effective transmission range.
* Although remote transmitter are weather proof, it is recommended to place
it away from direct sunlight, rain or snow. This will help to make measure-
ment more accurate.
The building materials and where the receiver and remote transmitter are
positioned vastly affect the effective range. Try various set-ups for best result.
Setting remote transmitters
1. Remove the battery cover and insert LR6/AA size
batteries to start setup. Insert the batteries
between terminals observing proper polarity.
. The number for HOuSe CODe will flash for 8 seconds.
3. Select HOuSe CODe ("01" to "15") to by pressing C/F
while the number is flashing.
4. Press SET to complete HOuSe CODe setting. Channel will flash for 8 sec.
5. Select channel (1-4) by pressing C/F. This number will be confirmed upon
pressing the SET button, or if no key is pressed for 10 seconds. If only one
transmitter is available, it is recommended to leave the CHANNeL be "01".
It means it is for detecting OuTSIDe weather.
6. Temperature will display.
7. Switch between °C and °F of Temperature by pressing C/F.
8. Replace the cover.
- use a different house code if your weather station detect other signals
from neighboring sources.
- Factory default: house code = 01 and channel = 01.
Setting the receiver
Remove battery cover and insert xLR6/
AA size batteries. Insert between terminals
observing proper polarity then replace the
cover.
5
1 2
1 2