Connecting To A Pc; Connecting To A Tv Antenna - Teac LCDV2655HD User Manual

System Connections

Connecting to a PC

Follow the steps and figure below to connect PC to the unit.
1. Connect one end of the VGA cable to the VGA input jack on the jack panel of the unit and the
other end to the PC VGA output.
2. Connect one end of the audio cables to the PC audio input jack on the jack panel of the
television and the other end to the PC audio output jack.
3. Set the PC video resolution to match that of the television (typically 1024 x 768@60Hz).
After connection, turn on the power of the unit and the external AV signal source. Press INPUT then
direction buttons to select VGA mode, and then press the ENTER button to confirm.

Connecting to a TV Antenna

Connect TV signal input source from the aerial to the TV jack on the rear panel of the unit.
After connection, turn on the power of the unit. Then press the INPUT button and the direction
buttons to select TV or DTV mode, press the ENTER button to confirm and conduct program
selection.
- - 17