Remote Controller Description - Vivax ACP-09CH25GEEI User Manual

Operation of Remote Controller
1
ON/OFF:
Press this button to turn on the unit. Press this button again to turn off the unit.
▲
2
Press this button to increase set temperature. Holding it down above 2 seconds rapidly
increases set temperature. In AUTO mode, set temperature is not adjustable.
3 MODE:
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT
AUTO COOL
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
4
SWING:
Press this button to set up & down swing angle, which circularly changes as below:
This remote controller is universal . If any command
the unit will carry out the command as
indicates the guide louver swings as:
:
5
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly
decreases set temperature. In AUTO mode, set temperature is not adjustable.
6
FAN:
This button is used for setting Fan Speed in the sequence that goes from AUTO,
,
,
to
7 CLOCK:
P e r s s C L O C K b
present time.Holding down either button above 2 seconds increases or decreases the
time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
will be constantly displayed.
8
TIMER OFF:
Press this button to initiate the auto-off timer. To cancel the auto-timer program, simply
press the button again.TIMER OFF setting is the same as TIMER ON.

Remote Controller Description

* , as the following:
FAN HEAT
DRY
then back to Auto.
Auto
Low speed
Medium speed
t u o t , n b n i l k n i . g
*
*Note:Only for models with heating function.
OFF
W i h t n i 5 s e c o n d , s p
8
, or is sent out,
High speed
e r s s n i g + o - r b t u o t
,
n a d u j s s t h t e