Daylight Saving; Configuring Snmp - HP PS110 Configuration And Administration Manual

Daylight saving

Use this section to enable support for daylight saving time, if required for your location. When
you select Manually Set Time For Daylight Savings, additional fields display to enable
you to configure the starting and ending dates and times, and the DST offset.
The DST offset specifies how many minutes to move the clock forward or backward.
This page includes the following settings for Daylight Saving configuration:
Daylight saving
•
Enable: Enables daylight saving for the system time. The router automatically sets daylight
saving start and end dates based on the time zone selected.
•
Manually Set Time For Daylight Savings: Sets the dates for starting and ending the
daylight saving.

Configuring SNMP

The Simple Network Management Protocol (SNMP) enables the remote management of the HP
PS1 10 router by a computer that has SNMP management software installed. The HP PS1 10
provides a robust SNMP v1/v2c implementation supporting both industry-standard MIB II
objects and HP-specific MIB objects. Read-only and read-write access are supported.
Select System > SNMP to open the SNMP configuration page.
To configure SNMP, set the following options:
•
Enable SNMP: Use this checkbox to enable/disable the SNMP agent. By default, the
SNMP agent is disabled. When the agent is disabled, the HP PS1 10 does not respond to
SNMP requests.
Configuring SNMP 25