Slaac - HP PS110 Configuration And Administration Manual

SLAAC

Stateless Address Auto Configuration (SLAAC) enables IPv6 hosts to automatically configure
themselves when connected to an IPv6 network using the Neighbor Discovery Protocol through
the Internet Control Message Protocol version 6 (ICMPv6) route discovery message. When first
connected to a network, a host sends a link-local router solicitation multicast request for its
configuration parameters; routers respond to such a request with a router advertisement packet
that contains Internet Layer configuration parameters.
This page includes the following settings:
Connection Settings
Sets basic IPv6 address configuration settings.
•
IPv6 Connection: Select SLAAC for the IPv6 address connection mode.
DNS Settings
Configures IPv6 DNS settings:
•
Obtain IPv6 DNS servers automatically: Sets the IPv6 addresses for primary and
secondary DNS servers automatically.
•
Use the following IPv6 DNS servers: Enter the primary and secondary DNS server
IPv6 addresses.
VLAN (Default) Settings
Sets the IPv6 settings for the local VLAN.
•
Enable DHCP-PD: Enables the Prefix Delegation feature that automatically uses an IPv6
prefix for the local LAN defined by the ISP. When disabled, the IPv6 address and prefix
length need to be manually defined.
104 IPv6 configuration
•
IPv6 Address: The IPv6 address of the router for the local LAN.
•
Subnet Prefix Length: The prefix length of the IPv6 address.