Hangar 9 P-51D 1.50 ARF Assembly Manual page 9

 
. .Step 4
Deflect.the.aileron.and.apply.thin.CA.to.the.hinge..Apply.
enough.CA.to.completely.saturate.the.hinge..Use.care..
not.to.deflect.the.aileron.so.it.pulls.away.from.the.wing..
When.the.hinge.is.glued.in.place,.there.should.be.no.
more.than.a.1/64".hinge.gap.maintained.throughout.the.
length.of.the.aileron..Turn.the.wing.panel.over,.deflect.the.
aileron.in.the.opposite.direction,.and.apply.thin.CA.to.the.
other.side.of.the.hinges.
 
. .Step 5
Use.CA.remover/debonder.and.a.paper.towel.to.remove.
any.excess.CA.accumulated.on.the.wing.or.aileron.
surface..Allow.time.for.the.CA.to.completely.cure.before.
moving.to.the.next.step.
Section 1: Aileron and Flap Installation
 
. .Step 6
Firmly.grasp.the.wing.and.aileron.and.gently.pull.on.the.
aileron.to.ensure.the.hinges.are.secure.and.cannot.be.
pulled.apart..Use.caution.when.gripping.the.wing.and.
aileron.to.avoid.crushing.the.structure.
 
. .Step 7
Work.the.aileron.up.and.down.several.times.to.work.in.the.
hinges.and.check.for.proper.movement.
9