Mac Filtering - NetComm NB1300 Plus 4W User Manual

MAC Filtering

The MAC Filtering configuration page allows the user to set the configuration of IP filtering.
Enable and disable MAC filtering by selecting the 'Yes' or 'No' radio buttons.
Source MAC: When the bridge filtering is enabled, enter the Source MAC address, select
Block and click Add. Then all incoming WAN and LAN Ethernet packets matched with this
source MAC address will be filtered out. If the Forward is selected, then the packets will be
forwarded to the destination PC.
Destination MAC: When the bridge filtering is enabled, enter the Destination MAC
address, select Block and click Add. Then all incoming WAN and LAN Ethernet packets
matched with this destination MAC address will be filtered out. If the Forward is selected,
then the packets will be forwarded to the destination PC.
Type: Enter the hexadecimal number for the Ethernet type field in Ethernet_II packets.
For example, 0800 is for IP protocol.
0800 - IP Protocol
A5FF - Ethernet
Rev. 1 - YML672
NB1300_2 ADSL Modem
www.netcomm.com.au
Page 53