Adsl Configuration - NetComm NB1300 Plus 4W User Manual

ADSL Configuration

The ADSL Configuration page allows the user to set the configuration for ADSL protocols.
Trellis: This field allows the user to enable or disable the Trellis Code. By default, it is
always enabled.
Handshake Protocol: This field allows the user to select the ADSL handshake protocol.
Wiring Selection: This field allows the user to enter the wiring selection for the RJ-11.
Tip/Rip is the default for the board without the inner/outer pair relay
Bit Swapping: This field allows the user to enable or disable the upstream bit swapping.
Rev. 1 - YML672
NB1300_2 ADSL Modem
www.netcomm.com.au
Page 49