Basic Menu - NetComm NB1300 Plus 4W User Manual

Basic Menu

One Page Setup
The One Page setup page is designed to make the most commonly required configuration fields
available all in one place. For most installations you will only need to use the one-page setup to
configure the unit. One-Page setup fields all apply to Virtual Circuit zero only (see section on
Multiple Virtual Circuits elsewhere in this manual for more information).
LAN:
This the Local Area Network IP address of the NB1300, by default this is set to 192.168.1.1
this can be changed to reflect your network requirements, IE 172.16.1.1 or 10.0.0.1
For simple networks it is suggested that the default addresses be used.
WAN:
This is the field that you configure your ISP details, enter the details provided by your ISP into
these fields:
Service name - This is the name you wish to call the connection, it is recommended that
you use your ISP's name to avoid confusion at a later date. For example if you use Ozemail
as your ISP then enter 'OzEmail' in the service field. Your ISP does NOT set this field.
Username - This is the Username provided by your ISP. Please check with your ISP as to
the format to use, some ISPs use your full Username (IE user@ISP.com.au) and some just
use the username only.
Rev. 1 - YML672
NB1300_2 ADSL Modem
www.netcomm.com.au
Page 35