BMW 730i Owner's Handbook Manual page 55

Suitable ISOFIX child restraint systems
The following ISOFIX child restraint systems
may be used on the front seats in your vehicle.
The corresponding designations can be found
on the child seats.
A - ISO / F3
B - ISO / F2
B1- ISO / F2X
C - ISO / R3
D - ISO / R2
E - ISO / R1
Brackets for lower ISOFIX anchors
Before fitting the child seat, pull the belt away
from the area around the child seat mountings.
Make sure that both lower ISOFIX
anchors are properly engaged and that
the child restraint system is resting securely
against the seat back.<
Rear seats
The brackets for the lower ISOFIX anchors are
located at the positions marked by the arrows,
in the gap between the seat and the seat back.
Fitting aid
The fitting aid makes it easier to fit ISOFIX child
restraint systems and also protects the surface
of the seat upholstery.
The fitting aid can be obtained from BMW
Service. Observe the operating and
safety instructions of the fitting aid manufac-
turer.<
Online Edition for Part no. 01 41 0 013 197 - © 02/07 BMW AG
Firmly press the fitting aid in at the parting line
between the base and back cushions, such that
both funnels engage in the ISOFIX anchors
located in the seat.
To remove, pull off the fitting aid.
Mounting points for upper ISOFIX
retaining strap
Use the mounting points for the upper
ISOFIX retaining strap only to secure
child restraint systems; otherwise, the mount-
ing points could be damaged.<
There are two additional mounting points for
ISOFIX child restraint systems with an upper
retaining strap, see arrows.
Path for the upper retaining strap
Make sure that the upper retaining strap
does not pass over sharp edges and is not
twisted on its path to the upper mounting point.
Otherwise the child restraint system cannot
protect the child as intended in the event of an
accident.<
53