Recording Bit Length Settings (Depth); Initial Value Settings For The Recorded Scene Number - NAC Image Technology MC-529 User Manual

3.2.10 Recording Bit Length Settings (DEPTH)

While in the VIEW mode, the recording bit length can be set from the VIEW MENU on the J-PAD3.
It is possible to alter the number of bits per pixel for the recorded image. With a high bit rate, the gradation
of the image (the amount of change in brightness) of the image is finer and results in better image quality.
With a low bit rate, the gradation of the image is rougher and it is possible to economize on the recording
memory, and extend the recording time.
1) While in the VIEW mode, press MENU
VIEW MENU.
2) Select "DEPTH" from the VIEW MENU using the arrows
.（Figure 3-24）
3) Use the arrows
8 8 bit
10 10 bit (standard image setting)
12 bit (high quality image)
12
3.2.11 Initial Value Settings for the Recorded Scene Number (SCENE)
While in the VIEW mode, the initial value for the recorded scene number can be set from the VIEW MENU
on the J-PAD3.
The initial value for the recorded scene can be set from 0～65535. The recorded scene number adds +1
each time recording is completed.
1) While in the VIEW mode, press MENU
VIEW MENU.
2) Select "SCENE" from the VIEW MENU using the arrows
and press SET
3) Use the arrows
to change the numerical value. (Range：0～65535)
4) Press SET again to set the initial value for the recorded
scene number.
to select the recording bit length.
.（Figure 3-25）.
to move columns and use arrows
to display the
to display the
3-16
Figure3-24 DEPTH
Figure3-25 SCENE
(00235)