Shallow Water; Power Trim And Tilt Models; Cruising In Other Conditions - Yamaha F200B Owner's Manual

EMU28062

Shallow water

EMU32871

Power trim and tilt models

The outboard motor can be tilted up partially
to allow operation in shallow water.
ECM01490
NOTICE
If the engine speed is suddenly in-
G
creased when the outboard motor is par-
tially tilted up, the power trim and tilt unit
could be damaged.
Do not tilt the outboard motor up so that
G
the cooling water inlet on the lower unit
is above the surface of the water when
setting up for and cruising in shallow
water. Otherwise severe damage from
overheating can result.
EMU32922
Procedure for power trim and tilt models
1. Place the remote control lever in neutral.
N
ZMU04588
2. Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch. WARNING! Using the power
trim and tilt switch on the bottom
cowling while the boat is moving or
engine is on could increase the risk of
falling overboard and could distract
the operator, increasing the risk of
collision with another boat or an ob-
stacle.
[EWM01850]
3. To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU28195

Cruising in other conditions

Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
ter.
Cruising in muddy, turbid, or acidic water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(see page 13) if you use the outboard motor in
acidic water or water with a lot of sediment in
it, such as muddy or turbid (cloudy) water. Af-
ter operating in such water, flush the cooling
passages with fresh water to prevent corro-
sion. Also rinse the outside of the outboard
motor with fresh water.
Operation
54