Table Of Contents; Rotation Speed; Move Stationary Point - Agatec A510S Owner's Manual

Quick start
Functions using the laser keypad
On/Off Press
Rotation speed Increase with
Stop rotation Press and hold
Chalk line Flip collar on head up for chalk line,
down for point
Move stationary point
or chalk line left Press

Move stationary point

or chalk line right Press
Scanning Press simultaneously on
Increase scan angle Press
Decrease scan angle Press
Move left
scan or vertical alignment Press
Move right
scan or vertical alignment Press
H.I. Alert Press H.I.
Motorized mount mode Press simultaneously on
(scan keys) for several seconds; all 3
LEDS will blink and 4 beeps will sound
Raise laser on mount Press
Lower laser on mount Press
Manual mode Press
(slope on X axis) (bottom LED will blink)
* Functions not available in wall mount mode; exit to use these functions.
2
; decrease with
until it stops
and
(in scan mode)
(in scan mode)
*
*
and
(in wall mount mode) on remote
(in wall mount mode) on remote
Man*

Table of contents

1. General information
1.1. Description
1.2. Safety
1.3. Specifications
1.4. Laser overview
1.5. Keypad overview
2. How to use the laser
2.1 Setup
2.2 Automatic/Manual
2.3 HI Alert

2.4 Rotation speed

2.5 Laser chalk line
2.6 Scanning
2.7 Motorized mount
2.8 Squaring
2.9 Matching slope
3. Power
3.1 Installing alkaline batteries
3.2 Using rechargeable batteries
3.2 Later recharging
4. Checking and adjusting calibration
5. Care and handling
6. Accessories
6.1 Detector and troubleshooting
6.2 Remote control
6.3 Tripods
6.4 Other accessories
7. Warranty
4
7
14
15
21
22
26
3