Problems With System Repair - NEC Express 320Lc User Manual

6-24 Troubleshooting

Problems with System Repair

Cannot create the "Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER" with
"NEC Express5800/ft series Update CD".
Is the command properly specified?
→ Make sure to specify the LANGENG since it is an argument. "Windows Server 2003
OEM-DISK for NEC EXPRESSBUILDER" will not be created if LANGENG is not
specified as an argument. For details, see 'If you have an update CD-ROM "NEC
Express5800/ft series ft Update CD (Ver:n.n)"' in "System Repair" in this chapter.
The screen to select HAL was not displayed on Starting up the Recovery Console.
Did you immediately enter <F5> and <F6> when the Recovery Console is starting?
→ Recovery Console will not start if a screen to select HAL was not displayed by pressing
F5 and F6 on "Starting up the Recovery Console". Immediately press F5 and F6 when
"Press F6 if you need to install a third party SCSI or RAID driver..." is displayed on the
bottom of a screen. A screen to select HAL will be displayed. Restart the system if a
screen is not displayed, and see "Starting up Recovery Console" in "System Repair" in
this chapter to restart the Recovery Console.
"Press F6 if you need to install a third party SCSI or RAID driver..." was not displayed
and there was no chance to enter
from Windows Server 2003 CD-ROM" was performed.
Did you press any key when the message "Press any key to boot from CD" is displayed on
top of the screen?
→ Start-up from Windows Server 2003 CD-ROM is required to start the Recovery Console
from Windows Server 2003 CD-ROM. Press any key while the message "Press any key
to boot from CD" is displayed on the screen. You cannot start the recovery console from
the CD-ROM unless the any key is pressed while the message is being displayed. Restart
the system when it does not start from CD-ROM and the message "Press F6 if you need
to install a third party SCSI or RAID driver..." is not displayed. See "Starting up
Recovery Console" in "System Repair" in this chapter to start again.
The screen turns out to be black for a while when booting the Recovery Console.
→ If you start the Recovery Console that is installed in the system, the screen turns out to be
black for a while when booting the Recovery Console. Since the system is normally
working, please wait for a while.
When the system's update is being processed, Operating System Stop Error occurred at
the system reboot.
→ During the system update process, the message "Windows-FT Orphaning A disk that is
part of a fault–tolerant volume can no longer be accessed" is displayed, and there is
sometimes a case that OS Stop Error occurs on a reboot after this process. See
IMPORTANT of step 6 in "Updating the System" in this chapter when OS Stop Error
occurs, and reboot the system. In addition, the system's update is successfully being
performed when the message "Windows-FT Orphaning A disk that is part of a
fault-tolerant volume can no longer be accessed" is displayed. However, the mirroring of
HDD is not applied. Make sure to check the hard disk's mirroring after the system
start-up.
F5 F6
and when "When starting Recovery Console