Operating Multiple Projectors With Remote Control - NEC MultiSync XT5000 User Manual

Operating Multiple Projector with Remote Control
You can operate multiple projectors with the same remote control in wireless operation.
To do so:
1. Select [Main Menu] [Projector Options] [Setup] [Page 3] [Projector ID] and assign an ID number to each projector. See also
page E-40.
2. On the remote control specify the ID number of the projector to be adjusted. Press and hold the CTL and press MENU (ADDRESS)
button to enter the ID number.
You can operate the projector assigned the same ID number as the remote control.
Projector ID= 01
You can daisy-chain multiple projectors and operate them separately with the same remote control in wired operation.
To do so:
Use the remote control cable to connect the Remote Control Output of one projector to the Remote Control Input of the next until all
the projectors are connected. Only one remote control cable is supplied with the projector. Additional remote control cables are
optional.
REMOTE 2
IN
OUT
Remote Address = 03
Projector ID= 02
Remote Address = 03
Projector ID= 01
E – 28
Projector ID= 03
Projector ID= 02 Projector ID= 03