Table of Contents
Advertisement
Setting Up The projector
To set up and use the projector, you must first do:
1. Determine the screen size and the optional lens to be used.
NOTE: Refer to page E-14 for lens installation.
2. Set up a screen or select a non-glossy white wall onto which you
can project your image.
Moving The Projector
Always carry your projector by the handle. Ensure that the power cord
and any other cables connecting to video sources are disconnected
before moving the projector. When moving the projector or when it is
not in use, cover the lens with the lens cap.
Pulling Out the Handles
Pull out the handle until it clicks into place.
Retracting the Handles
1) Push the lever to unlock and 2) retract the handle.
Selecting A Location The further your projector is from the screen or
wall, the larger the image. The minimum size the image can be pro-
jected is 80" (2 m) measured diagonally. The largest the image can be
is 500" (12.7 m).
100"
80"
WARNING
• Only use your projector on a solid, level surface. If the projector
falls to the ground, you can be injured and the projector severely
damaged.
• Do not use the projector where temperatures vary greatly. The pro-
jector must be used at temperatures between 40 degrees F (5 degree
C) and 95 degrees F (35 degree C).
• Do not expose the projector to moisture, dust, or smoke. This will
degrade the screen image.
• Ensure that you have adequate ventilation around your projector
for proper heat dissipation. Do not cover the vents on the projector
cabinet.
E – 16
500"
400"
300"
200"
Advertisement
Table of Contents
