Let's get started!
Once you have all your tools together, please follow each step carefully and in order.
Because this is an electronic lock, the order of steps is very important. If you skip a
step, you may have to perform a factory default reset and start over.
You will definitely need this tool:
• Phillips screwdriver
You can use a manual or electric
screwdriver, but please DO NOT use a
power drill!
INSTALLATION NOTES! PLEASE READ!
• DO NOT use a power drill for installation! This could damage the lock.
• Please read all the instructions before calling customer support.
• DO NOT install the batteries before installing the lock! Follow the instructions
in order!
• If you have previously installed this lock on another door, you MUST perform a
Factory Default Reset FIRST! See the User's Guide for more information.
• This lock is designed for the following operating temperatures:
• Outside Lock Body (exterior mounted): -31˚F (-35˚C) to 151˚F (66˚C)
• Inside Lock Body (interior mounted): 14˚F (-10˚C) to 120˚F (49˚C)
Steps at a Glance
1
2
3
Watch the online video. ....................................................................................................... 4
4
5
6
Install bolt and strike. ...........................................................................................................6
UPDATE
6e Test bolt alignment. ...................................................................................................................... 8
7
8
9
Install the Batteries. ..............................................................................................................11
9b Install the battery cover. ............................................................................................................12
10 Set up the Lock. .....................................................................................................................12
11
Test the Lock. .........................................................................................................................12
You may also need these tools:
• Tape Measure
• Flathead Screwdriver
• Pencil
• Wood Block
• Hammer
3