ZyXEL Communications ZyAIR b-2000 Quick Installation Manual page 32

2.
Turn the desktop holder up to the right.
3. Refer to the Hardware Connections section. Connect the cables to the ports on the ZyAIR
through the desktop holder.
4. Turn the desktop holder down and place the unit on a flat, sturdy surface (on a desk or shelf).
Wall-mounted
Follow the steps to attach your ZyAIR to a wall.
Step 1. Locate a high position on the wall that is free of obstructions.
2.
You can use the diagram at the end of this guide to help you mark the screw holes correctly. Use
screws with 6mm ~7.5mm (0.24" ~ 0.30") wide heads. Connect two screws (not included) in the
wall 80mm (3.15") apart. Do not screw the screws all the way into the wall. Leave a small gap
between the head of the screws and the wall.
ZyAIR B-2000 v. Broadband Wireless Sharing Router
2
Figure 9 Instructions using the Desktop Holder
32