Hardware Connections; Side Panel And Connections; The Front Panel - ZyXEL Communications ZyAIR b-2000 Quick Installation Manual

2 Hardware Connections

2.1 Side Panel and Connections

LABEL DESCRIPTION AND FUNCTION
1. LAN Use an Ethernet cable to connect at least one computer for initial ZyAIR configuration.
These ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-crossover
(automatically adjust to the type of Ethernet cable you use (straight-through or
crossover)).
2. WAN Connect your cable/DSL modem to this port with the cable that came with your modem.
3. POWER Connect the end of the included power adaptor (use only this adaptor) to this power
socket.
After you've made the connections, connect the power cable to a power supply and look at the front panel
LEDs.
RESET You only need to use this button if you've forgotten the ZyAIR's password. It returns the
ZyAIR to the factory defaults (password is 1234, LAN IP address 192.168.1.1 etc. see
your User's Guide for details).

2.2 The Front Panel

The PWR LED turns steady on when the power cord is connected. The SYS LED blinks while performing
system testing and then turns steady on if the testing is successful. The link LED and the ZyAIR LED turn
steady on while the wireless card on the ZyAIR is working. The LAN and WAN LEDs turn on, if they are
properly connected. Refer to the User's Guide for more detailed LED descriptions.
ZyAIR B-2000 v. Broadband Wireless Sharing Router
2
5