Bottom Trim - Amana SXD25S2 Service

Kit Instructions
16. Install bottom dispenser trim (Item #7) by placing
trim at an angle on top edge of lower freezer panel.
Press trim onto panel. Install lower ice and water
freezer door panel trim (Item #9) by placing trim on
right edge of lower freezer panel. Press trim onto
panel. Trim pieces must overlap at the corner.
Caution
To prevent property damage, place
on back of panel at each
panel from damaging doors.
17. Place masking tape on back of panels at each
corner.
18. Slide decorator door panels into place under handle
trim until panels are secure.
December 1997
masking tape
corner. Tape prevents
19. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against top
corner of refrigerator cabinet over edge of top trim.
After checking placement, peel off backing and
press into place. Place side door trim over edge of

bottom trim.

20. Push water tube into plastic union nut and tighten
union nut by hand. Gently pull on tube to confirm
nut is tight. Tighten water tube clamp screw.
Caution
To avoid property damage, confirm water tube union
nut is secure and check for leaks before replacing toe
grille.
21. Replace toe grille by inserting clips in holes and
snapping in.
81 RS1300003 Rev. 0