Amana SXD25S2 Service page 95

Kit Instructions
Important
Permanent, double-sided tape is used to attach some
trim pieces to refrigerator. Before removing paper
backing, check placement of trim pieces on refrigerator.
Trim pieces may be damaged if adjustment or removal
is attempted after installation.
25. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against
bottom corner of refrigerator cabinet over edge of
bottom trim. After checking placement, peel off
backing and press into place. Place side door
trim under edge of top trim. Tighten top trim
screws.
26. Push water tube into plastic union nut and tighten
union nut by hand. Gently pull on tube to confirm
nut is tight. Tighten water tube clamp screw.
Caution
To avoid property damage, confirm water tube union
nut is secure before replacing toe grille.
27. Install new toe grille (if supplied) by inserting clips
in holes and snapping in. Top of toe grille is
indicated on back of toe grille.
December 1997
Bottom Trim
95
Side Trim
RS1300003 Rev. 0