Handle Side Door Trim Retainers; Door Gasket; Inner Door Liner; Low Voltage Board - Amana SXD25S2 Service

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Handle Side Door Trim Retainers

1. Remove door trim by prying up carefully under
outside edge of retainer.
2. Remove phillips mounting screws.

Door Gasket

1. Remove door.
2. Place door face down on a protected surface with
door handle extending beyond the edge of surface.
3. Lift gasket away from door and loosen all
mounting screws.
4. Pull gasket out and away from door liner.

Inner Door Liner

1. Remove Door.
2. Place door face down on a protected surface with
door handle extending beyond edge of surface.
Door Position to Remove Inner Door Liner
3. Lifting gasket away from the door, remove all
mounting screws, retainers (freezer door only),
and gasket.

Low Voltage Board

1. Remove door handle.
2. Remove four mounting screws holding circuit
board to refrigerator door.
3 Tilt board and pull board from cavity.
4. Unplug connector from board by inserting flat
blade screwdriver in either end of connector and
pry apart.
NOTE: Do not try to unplug connector by pulling on wire
harness.
RS1300003 Rev. 0
!
WARNING
Ice and Water Cavity
1. Remove escutcheon by removing two phillips
screws at bottom of escutcheon and lifting
escutcheon off.
2. Remove electric mounting bracket by removing
mounting screws at each side of plate.
3. Remove ten screws securing perimeter of cavity to
door.
4. Pull out top of cavity slightly exposing where
waterline held in notch by washer type clip.
5. Push electrical grommet back and out of cavity
hole in left side of cavity.
6. Tip cavity out at top and lift slightly so cavity sump
clears bottom edge of opening.

Cavity Heater

1. After removing cavity, unplug cavity heater from
door harness.
2. Carefully peel cavity heater off back of cavity.

Electrical Mounting Bracket

1. Remove escutcheon by removing two phillips
mounting screws at bottom of escutcheon and
lifting escutcheon off.
2. Remove mounting screws at each side of plate.
3. Separate bracket from cover to access Ice
Dispenser Switch, Water Dispenser Switch, Cavity
Light Switch, Cavity heater Switch, Cube/Crushed
Switch, and Cavity light bulb.

Water Actuator Arm

1. Remove escutcheon and electrical mounting
bracket.
2. Remove two screws and two retainers.
3. In reassembly, return spring straddles arm and
rides up against top section of arm.

Ice Actuator Arm

1. Remove escutcheon and electrical mounting
bracket.
2. Remove two screws and the two retainers.
3. Slide arm down and out from under chute door
while disconnecting door closure delay
mechanism.

Door Closure Delay Mechanism (Ice and Water Models)

1. Remove one screw.
2. Disconnect from ice actuator arm and remove.

Chute Door (Ice and Water Models)

1. Remove escutcheon, electrical bracket, and ice
actuator arm.
2. Remove two screws to remove chute door, spring,
and hinge from cavity.
3. To separate chute door from hinge, remove pin.
60 December 1997