Electronic Models; Dispenser Models; Door Stop And Top Door Closure; Freezer Door Top Hinge - Amana SXD25S2 Service

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Freezer or Refrigerator Door
1. Remove toe grille.

Electronic Models

2. Unplug wiring harness from voltage box.
High Voltage Box

Dispenser Models

3. Loosen water tube clamp screw. Loosen plastic
water tube union nut. Pull water tube away from
union nut and through tube clamp.
Water tube
Water Tube Connection

Door Stop and Top Door Closure

1. Remove door from cabinet.
2. Remove screw mounting top door closure.
3. Remove two screws mounting door stop to bottom
edge of door.
RS1300003 Rev. 0
!
WARNING

Freezer Door Top Hinge

1. Secure freezer door to cabinet in closed position
2. Remove freezer hinge cover.
3. Unplug cabinet to freezer door wiring harness
Plastic water tube
union nut
4. Remove ground screw and three freezer hinge to
5. If present, slide hinge and nylon door bushing out

Combination Door Closure and Lower Hinge

1. Remove door from cabinet.
2. Remove one bottom door closure mounting screw
Water tube
clamp screw
3. Remove two hinge mounting screws and door
58
with strapping tape.
!
CAUTION
To prevent personal injury or property damage due to
door falling, always secure door to cabinet with
strapping tape before top hinge is removed.
Hinge
cover
Door
hinge
screws
Top
hinge
connector blocks.
cabinet mounting screws.
of door and off freezer door wiring harness.
and remove closure.
hinge.
Wire
harness
connectors
Ground
wire
December 1997