Drawer Assembly; Drawer Rails; Rack And Pinion Gear; Bottom Of Cabinet Front Roller Assembly - Amana AB1924PEK Series Instruction Manual

Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all earthing wires are connected before certifying unit as repaired and/or operational.
Drawer Assembly (some models)
1. Open drawer to fully open position.
2. Remove upper basket.
3. Remove screws one in each rail marked on side of
rail.
4. Lift front of drawer up and out to remove drawer.

Drawer Rails

1. Remove screws inside plastic rail retainer.
2. Remove rails from retainer by depressing plastic tabs
on back side of retainer.
3. Slide rails off of retainer.

Rack and Pinion Gear

1. Remove drawer assembly (see Drawer Assembly
Removal).
2. Extend drawer rails to full open position,remove rails
from retainer by depressing plastic tabs on back side
of retainer.
3. Slide rails, rack and pinion gear off of retainer.
4. Reverse procedure to reassemble.
Note: When reinstalling rails, rack and pinion gear after
latching rails in place, slide rails, rack and pinion
to the fully closed position and then pull out to
synchronize the rack and pinion gears.
Bottom of Cabinet
Front Roller Assembly
1. Remove toe grille by pulling it straight away from unit.
2. Raise front of refrigerator at least 101.6mm off the
deck and block it up.
3. Unscrew leveling bolt until wheel is free of leveling
bolt.
4. Tip wheel assembly down until wheel assembly will
slide out of mount from the rear of assembly.
5. Remove roller assembly from unit.

Rear Roller Assembly

NOTE: Condensate drip pan may spill when steps 1
thru 4 are performed. Have a towel ready to
mop up spillage.
1. Tape both doors shut to prevent doors from opening
2. Raise back of refrigerator at least 101.6mm off the
deck and block it up.
3. Remove machine-compartment cover.
4. Locate and slide roller pins out of rollers.
5. Install new rollers and reinstall pins.
©2004 Maytag Services
!
WARNING

Machine Compartment

Condenser Fan & Fan Motor
1. Remove machine compartment cover.
2. Unplug wiring harness connector from fan motor.
3. On backside of fan motor, screws secure the motor to
its brackets. Remove those screws.
4. Note which side of fan blade is "front" and which side
is "rear." Then use pliers to loosen nut that secures
fan blade to motor shaft. Remove nut and fan blade.

Compressor

NOTE: Install new drier and compressor per
instructions in "Service Procedures." Evacuate
and recharge sealed system per instructions in
"Service Procedures."
1. Remove machine compartment cover.
2. Remove drier.
3. Disconnect all compressor wiring and overload/relay
assembly.
4. Unbraze low and high pressure lines at compressor.
5. Remove compressor mounting bolts.
6. Lift compressor out of unit.
16023324 Rev. 0
CO N DEN SER F AN
H AR N ESS P LUG
W ATE R VALVE
COV ER
M A CHIN E CO M PART M ENT
C OVER
33