Preparing The Measurement - Sanitas SBM 52 Instructions For Use Manual

4. Preparing the measurement

Insert the batteries
• Open the battery compartment lid.
• Insert four 1.5 V AA (alkaline type LR6) batteries. Make sure that the bat-
teries are inserted with the correct polarity, according to the label. Do not
use rechargeable batteries. The message "The device is ready for use.
You may start measuring." is displayed.
• Close the battery compartment lid again carefully.
• With inserted batteries, the unit permanently displays the time and date.
If the the low battery indicator
performed. The device will announce: "Battery weak." Please replace all batteries. Once the batteries have
been removed from the unit, the date, time and language must be set again.
Used batteries should not be disposed of in normal household waste. Dispose of them via
your electronics retailer or your local recycling point. You are legally obligated to do so.
Note: The codes below are printed on batteries containing harmful substances:
Pb: battery contains lead, Cd: battery contains cadmium, Hg: battery contains mercury.
Set date, time and language
This menu allows you to set the following functions, one after another.
Date Time Language
It is essential to set the date and time. Otherwise, you will not be able to save your measured values correctly
with a date and time and access them again later.
The time is displayed in 24-hour format.
In addition, the device has 3 language settings. The device is set to German when supplied to the cus-
tomer.
If you press and hold the function buttons
• Switch on the device with the Start/stop
• Press and hold the Memory button
The year flashes on the display.
• Set the year with the function buttons
Memory button .
• Set the month, day, hour and minutes and confirm each setting
with the Memory button .
The language will flash on the display
• You can select the following languages with the function buttons
= German
= English
= Spanish
= Language off
Confirm your selection with the Memory button .
= Language off means that there is no voice output and
therefore no acoustic playback.
and appear, no further measurements can be
Volume
, you can set the values more quickly.
button.
for 5 seconds.
and confirm with the
.
14
4 x AA (LR6) 1,5 V
Voice output
The device is ready for use.
You may start measuring.
:
Deutsch
English
Español